Footwear Testing Equipment

This is used to measure the strength the adhesion strength of sole at the toe and heel. It is widely used in shoe factories or at lab. This is available as per international quality standard.
Standard features includes:
• Load Range 0-100 kg x 500g
• Curvatures of toe-pieces 25,30,35, 40 and 45mm
• Length of contact arc 22mm

Related Standard:
• IS 8085 (Part 1) -1986
• IS 11226-1993, satra am4

Bennewart flex testing is used to determine the resistance of a component of material during repeated flexing. This testers are made using high quality die cast metal. This instrument is used to determine the physical properties of sole. Standard features includes: • Number of test specimens tested 2 for sole, 6 for cut test specimens • Angle of flexing 90° • Diameter of bending mandrel 30mm • Frequency of operation 125 to 150 cycle/minute • Counter Six digit pre-set type digital type RELATED STANDARDS: • DIN 53543 1979, SATRA PM 161

We are leading name in the manufacturing of shoe flex tester. This instrument is used to determine the flexing ability of shoe to withstand the different pressure of stresses produced on the different parts of the shoe. Uppers and Soles of a shoe are tested separately for flexing endurance. Standard features includes: • Flexing frequency 200 cycles/ minute • Maximum eccentricity 80mm Maximum angle of Flexing of shoe 35° • Motor 1/4 HP single-phase 230 volts AC.

Shape retention tester is used for checking the retention in shape of the shoe sole/ toe after compression under standard conditions and fixed load.
The same is measured as per standard methos written in is, the retention is measured with the help of a digital or dial thickness  or height gauge.